The Schecter 6202 Pasadena Plus is a six-string bridge pickup built for the bridge position only. It uses an Alnico V magnet in a direct-coupled construction and measures 16.0k ohms output — enough output to push hard into gain stages without losing note definition. The 4-conductor harness gives you split-coil capability, so you can run it full humbucker, split to a single coil, or wire it in parallel depending on what your switching layout allows.

Two things decide whether this pickup fits your guitar. First, spacing: this pickup is built to 53mm tremolo spacing, which is wider than neck-position spacing. If your bridge route was cut for a tighter spacing, the outer strings will not sit over the pole pieces. Measure across the outer two pole pieces of your existing pickup before ordering. Second, string count: this is a six-string pickup. It will not cover a seven- or eight-string spread. Also check how your bridge pickup is mounted — direct-mount bodies and ring-mount bodies need different hardware, and the 6202 will need to match your existing setup or you will need to sort the mount separately.

The baseplate is solid nickel/silver. Pole pieces are six nickel-plated carbon steel adjustable screws alongside six fixed nickel-plated carbon steel slugs. That combination lets you balance string-to-string output by adjusting the screw side, which matters more at the bridge than the neck because string-to-string imbalance is more audible there.

If you are not certain this spacing or mount configuration fits your guitar, send us the make, model and year and we will tell you before you buy.