This is the replacement tremolo arm for the Floyd Rose 1000 Series bridge. If the arm on your bridge is missing, bent, or stripped at the collar, this is the part that drops in. It is made from stainless steel with a satin gold finish, 6mm diameter and 80mm in length.

Fit is series-specific and this is where most mistakes happen. The shaft diameter, the collar interface — whether threaded or push-in — and the bend geometry all vary between Floyd Rose generations. This arm is cut for the 1000 Series. Put it in an Original Series, Special, or any other generation and it will not seat correctly. Left-handed arms are bent the opposite direction and are not swappable with right-handed ones — check which way your arm sweeps before ordering.

Stainless steel holds up better than the zinc or pot-metal arms found on lower-cost systems. The satin gold finish is matched to the 1000 Series satin gold bridge hardware, so a replacement here will not stand out against the original saddles and sustain block.

If you are not certain this is the right arm for your bridge, send us the make, model and year of your guitar and we will confirm before you order.